Dnp Binary Inputs (Uplc-Ii™ Inputs) - Ametek UPLC-II System Manual

7.2 DNP Binary Inputs (UPLC-II™
Inputs)
The UPLC-II™ has five physical binary inputs that
can be assigned numerous functions chosen from a
selection menu. The following tables include all
possible input selections for the UPLC-II™
ON/OFF and FSK modes. Since there are only five
Table 7–1. UPLC-II™ Inputs – DNP Points (ON/OFF Mode)
Point Name
0 Carrier Start Key
1 Carrier Stop Key
2 Low Level Key
3 CB Alarm Reset
4 CB Test Initiate
5 Loop Test Initiate
6 User SOE 1 Key
7 User SOE 2 Key
8 User SOE 3 Key
9 High Power Key
10 Low Power Key
Figure 7–3. DNP Binary Inputs / UPLC-II™ Inputs Settings Page
January 2016
inputs and many possible selections, at any given
time some of these selections will be unassigned or
not used. The on-line bits of these unassigned selec-
tions will be set to zero.
Setting Mode
All ON/OFF Modes
All ON/OFF Modes
All ON/OFF Modes
Checkback Option Only
Checkback Option Only
Checkback Option Only
All ON/OFF Modes
All ON/OFF Modes
All ON/OFF Modes
All ON/OFF Modes
All ON/OFF Modes
(Admin > Protocol > DNP > UPLC-II™ Inputs)
Chapter 7. Communication Protocols
Definition
Carrier Start Input has been Keyed
Carrier Stop Input has been Keyed
Low Level Keying Input has been Keyed
Checkback Alarms have been Reset
Checkback Test has been Initiated
Loop Back Test has been Initiated
SOE Event 1 Input has been Keyed
SOE Event 2 Input has been Keyed
SOE Event 3 Input has been Keyed
High Power Level has been Keyed
Low Power Level has been Keyed
7
Page 7–3