Dnp Binary Inputs(Uplc-Ii™ Outputs) - Ametek UPLC-II System Manual

UPlC-ii™ System manual
Point Name
0 3F DTT Trip Key
1 LR Trip Key
2 TX Power Off Key All FSK Modes TX RF Power Off Input Keyed (Turns TX Off for Test)
3 TX Pwr Boost Key All FSK Modes Power Boost Input has been Keyed
4 User SOE 1 Key
5 User SOE 2 Key
6 User SOE 3 Key
7 PC Key
8 Trip A Key
9 Trip B Key
10 Initiate Trip Test
11 2F DTT/POTT
Trip Key
12 TX Keyed Off
7.3 DNP Binary Inputs
(UPLC-II™ Outputs)
The UPLC-II™ has 10 or 14 binary outputs,
depending on the model. Like UPLC-II™ inputs,
you can assign these outputs in numerous ways.
The following tables include all possible output
selections for the UPLC-II™ ON/OFF and FSK
modes. Since there are more selections than out-
puts, at any given time some of these selections will
be unassigned and their on-line bits will be set to
zero.
Page 7–4
Table 7–2.
UPLC-II™ Inputs – DNP Points
(FSK Mode)
Setting Mode Definition
3-Freq. Only DTT Trip Input Keyed (for 3–Freq. Mode)
2 or 3-Freq. Line Relaying Trip Input Keyed (Unblock/2F, UB/POTT/3F)
All FSK Modes SOE Event 1 Input has been Keyed
All FSK Modes SOE Event 2 Input has been Keyed
All FSK Modes SOE Event 3 Input has been Keyed
Phase Comp. Phase Comparison Input has been Keyed
4-Freq. Only Trip Channel A Input has been Keyed
4-Freq. Only Trip Channel B Input has been Keyed
Testing Only Trip Test Input has been Keyed
Option Enabled (for Testing Purposes Only)
2-Freq. Only DTT Trip of POTT Trip Input has been Keyed
All FSK Modes Transmit Keyed Off