On/Off Mode Alarms - Ametek UPLC-II System Manual

UPlC-ii™ System manual

3.4 ON/OFF Mode Alarms

The following tables show alarms for ON/OFF Mode.
PS Hardware Failure Alarm for All UPLC-II™ Units
Alarm Reason:
Alarm Name:
(Available Outputs)
Contact Type:
UPLC-II™ Condition
PS Good
PS Bad
**For the Redundant Power Supply, use TB2-5 & 6
Software Programmable Alarms/(Outputs from I/O Board)
Alarm Reason:
Alarm Name:
(Available Outputs)
Contact Type:
UPLC-II™ Condition
All OK
Hardware Failure
Loss of DC Power
Page 3–14
Table 3–2.
Hardware Fixed Alarm (from Power Supply Board)
All Modes
One of the PS outputs is too low in voltage
Power Supply Alarm Output
(TB1-5 & 6)**
N.O. Contact
Closed
Open
Table 3–3.
ON/OFF Mode
Hardware Failure Alarm for All UPLC-II™ Units
Hardware health of at least one card is bad
General Alarm Output
(LL08 – LL10)
N.O. Contact
Closed
Open
Open
De-Energized State
N.C. Contact
Open
Closed
De-Energized State
N.C. Contact
Open
Closed
Closed