Ametek UPLC-II System Manual page 154

UPlC-ii™ System manual
Point Name
11 General Failure
12 RX Signal Off
13 TX Refl Pwr Alarm
14 RX Block Out
15 RX Carrier Out
16 TX Main RF On
17 TX Redundant RF On
18 Main PA Alarm
19 Redundant PA Alarm
20 Main PS Alarm
21 Redundant PS Alarm
22 CB Major Alarm
23 CB Minor Alarm
24 CB Delayed Alarm
25 CB Test Passed
26 CB Test in Progress
27 CB in Recovery
28 CB Recovered
29 Auto CB Tests Off
Page 7–6
Table 7–4.
DNP Binary Outputs – UPLC-II™ Outputs
(ON/OFF Mode)
Setting Mode Definition
All ON/OFF A Hardware Failure in the UPLC-II
All ON/OFF Received Level Dropped Below Fade Alarm
Setting (Active Unless Block Signal Received)
All ON/OFF % Reflected Power has Exceeded
Alarm Threshold Setting
All ON/OFF Carrier Block Output has Occurred
from the UPLC
All ON/OFF Carrier Receive Output has Occurred
from the UPLC
All ON/OFF TX Level on Main Power Amp
Above 0.5W
All ON/OFF TX Level on Redundant Power Amp
If Present Above 0.5W
All ON/OFF Main Power Amp has Failed
All ON/OFF Redundant Power Amp has Failed
If Present
All ON/OFF Main Power Supply has Failed
All ON/OFF Redundant Power Supply has Failed
If Present
If CB Option Checkback Major Alarm Occurred due to
Present Failure of High Level Checkback Test
If CB Option Checkback Minor Alarm Occurred due to
Present Failure of Low Level Checkback Test
If CB Option Checkback Delayed Alarm Occured due to
Present Failure to Exit Recovery Mode
If CB Option Successful Checkback Test
Present
If CB Option Checkback Test in Progress
Present
If CB Option UPLC-II
Present and is In Recovery Mode
If CB Option UPLC-II
Present Test Failure, No Delayed Alarm
If CB Option Automatic Checkback Tests
Present Have Been Turned Off
™
™
™
Failed Checkback Test
™
Successfully Recovered from a CB
™