Appendix E: Sequence Of Events (Soe) Listing - Ametek UPLC-II System Manual

Appendix E: Sequence of Events (SOE) Listing

Access Events
<User name> Logged off
<User name> Logged on
Front panel logoff
Front panel logon
User logged in
User logged out
Hardware Events
DC power down
DC power up
General alarm
General alarm reset
I/O board failed
I/O board restored
Main power supply failed
Main power supply restored
Main TX power low
Main TX power OK
Novram settings restored from flash memory of <Date>
Power amp failed
Power amp restored
Redundant power amp failed
Redundant power amp restored
Redundant power supply failed
Redundant power supply restored
Redundant TX power low
Redundant TX power OK
Battery Failure
Firmware Events
All UPLC™ settings initialized to default values
DSP checksum mismatch
Ethernet settings restored from flash memory
Ethernet settings restored from flash memory of <Date>
Ethernet settings set to default values
SOE file system repaired
Software Watchdog reset occurred (x)
Events cleared
January 2016
appendix e: Sequence of events (Soe) listing
E
Page e–1