Remove The Direct Connect Sata Cable - HPE ProLiant BL460c Gen10 User Manual

4. Install the access panel.
5. Install the server blade.
6. Power up the Server Blade .

Remove the direct connect SATA cable

The server uses SATA drives that can be removed if necessary.
Procedure
1. Power down the Server Blade .
2. Remove the Server Blade .
3. Place the Server Blade on a flat, level work surface.
4. Remove the access panel.
5. Remove the direct connect SATA cable.
a. Press in the latch on the connector.
b. Disconnect the connector from the system board.
c. Loosen the captive screw.
d. Disconnect the other end of the cable from the drive backplane.
e. Release the cable from the DIMM baffle.
28 Remove the direct connect SATA cable