Installing And Enabling The Hpe Tpm 2.0 Gen10 Kit; Installing The Trusted Platform Module Board - HPE ProLiant BL460c Gen10 User Manual

Before installing and enabling the HPE TPM 2.0 Gen10 Kit, verify that Chipset-TPM is disabled. For more
information on disabling Chipset-TPM, see the UEFI System Utilities User Guide for HPE ProLiant Gen10
Servers and HPE Synergy on the Hewlett Packard Enterprise website.

Installing and enabling the HPE TPM 2.0 Gen10 Kit

Installing the Trusted Platform Module board

Preparing the Server Blade for installation
Procedure
1. Observe the following warnings:
WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment, remove power from
the Server Blade by removing the power cord. The front panel Power On/Standby button does not
shut off system power. Portions of the power supply and some internal circuitry remain active until
AC power is removed.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
2. Update the system ROM.
Locate and download the latest ROM version from the Hewlett Packard Enterprise Support Center
website. Follow the instructions on the website to update the system ROM.
3. Power down the Server Blade (Power down the Server Blade on page 22).
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the Server Blade.
5. Do one of the following:
• Extend the Server Blade from the rack.
• Remove the Server Blade from the rack.
6. Place the Server Blade on a flat, level work surface.
7. Remove the access panel.
8. Remove any components or cables that may prevent access to the TPM connector.
9. Proceed to Installing the TPM board and cover on page 52.
Installing the TPM board and cover
Procedure
1. Observe the following alerts:
CAUTION:
If the TPM is removed from the original Server Blade and powered up on a different Server Blade,
data stored in the TPM including keys will be erased.
52 Installing and enabling the HPE TPM 2.0 Gen10 Kit