6.
Install the M.2 SSD into the M.2 riser:
a. Insert the M.2 SSD enablement board into the system board connector.
b. Secure the M.2 SSD enablement board by tightening the screw.
7.
Install the left DIMM baffle.
8.
Install the access panel.
9.
Install the Server Blade .
10. Power up the Server Blade .
Memory options
IMPORTANT:
This Server Blade does not support mixing LRDIMMs and RDIMMs. Attempting to mix any combination
of these DIMMs can cause the server to halt during BIOS initialization. All memory installed in the
Server Blade must be of the same type.
DIMM population information
For specific DIMM population information, see the DIMM population guidelines on the Hewlett Packard
Enterprise website (http://www.hpe.com/docs/memory-population-rules).
HPE Smart Memory speed information
For more information about memory speed information, see the Hewlett Packard Enterprise website (https://
www.hpe.com/docs/memory-speed-table).
DIMM label identification
To determine DIMM characteristics, see the label attached to the DIMM. The information in this section helps
you to use the label to locate specific information about the DIMM.
Memory options
45