Installing Server Blade Options; Installing Interconnect Modules; Interconnect Bay Numbering And Device Mapping - HPE ProLiant BL460c Gen10 User Manual

WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment, remove power from
the Server Blade by removing the power cord. The front panel Power On/Standby button does not
shut off system power. Portions of the power supply and some internal circuitry remain active until
AC power is removed.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
2. Update the system ROM.
Locate and download the latest ROM version from the Hewlett Packard Enterprise Support Center
website. Follow the instructions on the website to update the system ROM.
3. Power down the Server Blade (Power down the Server Blade on page 22).
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the Server Blade.
5. Do one of the following:
• Extend the Server Blade from the rack.
• Remove the Server Blade from the rack.
6. Place the Server Blade on a flat, level work surface.
7. Remove the access panel.
8. Remove any components or cables that may prevent access to the TPM connector.
9. Proceed to installing the TPM module and cover.

Installing server blade options

Before installing and initializing the Server Blade, install any Server Blade options, such as an additional
processor, hard drive, or mezzanine card. For Server Blade options installation information, see "Hardware
options installation."

Installing interconnect modules

For specific steps to install interconnect modules, see the documentation that ships with the interconnect
module.

Interconnect bay numbering and device mapping

• HPE BladeSystem c7000 Enclosure
Installing server blade options 17