Description; Destination - HPE FlexFabric 5950 Series Command Reference Manual

This command might fail to restore the default settings for some commands for reasons such as
command dependencies or system restrictions. Use the display this command in interface view to
identify these commands. Use their undo forms or follow the command reference to restore their
default settings. If your restoration attempt still fails, follow the error message instructions to resolve
the problem.
Examples
# Restore the default settings of Tunnel 1.
<Sysname> system-view
[Sysname] interface tunnel 1
[Sysname-Tunnel1] default

description

Use description to configure the description of an interface.
Use undo description to restore the default.
Syntax
description text
undo description
Default
The description of a tunnel interface is Tunnelnumber Interface, for example, Tunnel1 Interface.
Views
Tunnel interface view
Predefined user roles
network-admin
Parameters
text: Specifies a description, a case-sensitive string of 1 to 255 characters.
Usage guidelines
Configure descriptions for different interfaces for identification and management purposes.
You can use the display interface command to display the configured interface description.
Examples
# Configure the description of Tunnel 1 as tunnel1.
<Sysname> system-view
[Sysname] interface tunnel 1
[Sysname-Tunnel1] description tunnel1
Related commands
display interface tunnel

destination

Use destination to specify the destination address for a tunnel interface.
Use undo destination to restore the default.
Syntax
destination { ipv4-address | ipv6-address }
330