HPE FlexFabric 5950 Series Command Reference Manual page 342

Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
tunnel [ number ]: Specifies a tunnel interface. The number argument specifies the tunnel interface
number. The specified tunnel interface must have been created. If you do not specify the tunnel
keyword, this command displays information about all interfaces on the device. If you specify the
tunnel keyword without the number argument, this command displays information about all existing
tunnel interfaces.
brief: Displays brief interface information. If you do not specify this keyword, the command displays
detailed interface information.
description: Displays complete interface descriptions. If you do not specify this keyword, the
command displays only the first 27 characters of interface descriptions.
down: Displays information about interfaces in the physical state of DOWN and the causes. If you do
not specify this keyword, the command displays information about interfaces in all states.
Examples
# Display detailed information about Tunnel 1.
<Sysname> display interface tunnel 1
Tunnel1
Current state: UP
Line protocol state: UP
Description: Tunnel1 Interface
Bandwidth: 64kbps
Maximum transmission unit: 1476
Internet address: 10.1.2.1/24 (primary)
Tunnel source 2002::1:1 (Vlan-interface10), destination 2001::2:1
Tunnel TOS 0xC8, Tunnel TTL 255
Tunnel protocol/transport GRE/IPv6
GRE key disabled
Checksumming of GRE packets disabled
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
Table 73 Command output
Field
Tunnel1
Current state
Description
Information about the tunnel interface Tunnel 1.
Physical link state of the tunnel interface:
•
Administratively DOWN—The interface has been shut down
by using the shutdown command.
•
DOWN—The interface is administratively up, but its physical
state is down (possibly because no physical link exists or the
link has failed).
332