HPE FlexFabric 5950 Series Command Reference Manual page 343

Field
Line protocol state
Description
Bandwidth
Maximum transmission unit
Internet protocol processing:
Disabled
Internet address
Tunnel source
destination
Tunnel TOS
Tunnel TTL
Tunnel protocol/transport
GRE key disabled
Checksumming of GRE packets
disabled
Last clearing of counters
Last 300 seconds input rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
Description
•
UP—The interface is both administratively and physically up.
Data link layer state of the interface. The state is determined through
automatic parameter negotiation at the data link layer.
•
UP—The data link layer protocol is up.
•
UP (spoofing)—The data link layer protocol is up, but the link is
an on-demand link or does not exist. This attribute is typical of
null interfaces and loopback interfaces.
•
DOWN—The data link layer protocol is down.
Description of the tunnel interface.
Expected bandwidth of the tunnel interface.
MTU of the tunnel interface.
The tunnel interface is not assigned an IP address and cannot
process IP packets.
IP address of the tunnel interface. The primary attribute indicates
that the address is the primary IP address.
Source address of the tunnel. If a source interface is specified for the
tunnel interface, this field also displays the source interface in
parentheses.
Destination address of the tunnel.
ToS of tunneled packets.
TTL of tunneled packets.
Tunnel mode and transport protocol:
•
CR_LSP—MPLS TE tunnel mode.
•
GRE/IP—GRE/IPv4 tunnel mode.
•
GRE/IPv6—GRE/IPv6 tunnel mode.
•
IP/IP—IPv4 over IPv4 tunnel mode.
•
IPv6—IPv6 tunnel mode.
•
IPv6/IP—IPv6 over IPv4 manual tunnel mode.
•
IPv6/IP 6to4—IPv6 over IPv4 6to4 tunnel mode.
•
IPv6/IP ISATAP—IPv6 over IPv4 ISATAP tunnel mode.
•
UDP_VXLAN/IP—UDP-encapsulated IPv4 VXLAN tunnel
mode.
No GRE tunnel interface key is configured.
The GRE packet checksum feature is disabled.
Last time when counters were cleared.
Average input rate in the last 300 seconds.
Average output rate in the last 300 seconds.
Total input packets, total input bytes, and total input packets
dropped.
Input packets are counted after they are de-encapsulated by
software.
Total output packets, total output bytes, and total output packets
dropped.
Output packets are counted before they are encapsulated by
333