Ipv6 Dhcp Snooping Trust; Reset Ipv6 Dhcp Snooping Binding - HPE FlexFabric 5950 Series Command Reference Manual

The chip-supported maximum rate is an integer multiple of eight. If you set the maximum rate to 67,
the value 64 or 72 takes effect.
Examples
# Configure HundredGigE 1/0/1 to receive DHCPv6 packets at a maximum rate of 64 Kbps.
<Sysname> system-view
[Sysname] interface hundredgige 1/0/1
[Sysname-HundredGigE1/0/1] ipv6 dhcp snooping rate-limit 64

ipv6 dhcp snooping trust

Use ipv6 dhcp snooping trust to configure a port as a trusted port.
Use undo ipv6 dhcp snooping trust to restore the default state of a port.
Syntax
ipv6 dhcp snooping trust
undo ipv6 dhcp snooping trust
Default
After you enable DHCPv6 snooping, all ports are untrusted.
Views
Layer 2 Ethernet interface view
Layer 2 aggregate interface view
Predefined user roles
network-admin
Usage guidelines
Specify the port facing the DHCP server as trusted and specify the other ports as untrusted so DHCP
clients can obtain valid IP addresses.
Examples
# Specify HundredGigE 1/0/1 as a trusted port.
<Sysname> system-view
[Sysname] interface hundredgige 1/0/1
[Sysname-HundredGigE1/0/1] ipv6 dhcp snooping trust
Related commands
display ipv6 dhcp snooping trust

reset ipv6 dhcp snooping binding

Use reset ipv6 dhcp snooping binding to clear DHCPv6 snooping entries.
Syntax
reset ipv6 dhcp snooping binding { all | address ipv6-address [ vlan vlan-id ] }
Views
User view
Predefined user roles
network-admin
323