Remote-Server - HPE FlexFabric 5950 Series Command Reference Manual

If you do not specify an IPv6 address, the undo ipv6 dhcp relay server-address command
removes all DHCPv6 server addresses specified on the interface.
Do not enable the DHCPv6 client and the DHCPv6 relay agent on the same interface.
Examples
# Enable the DHCPv6 relay agent on VLAN-interface 2 and specify the DHCPv6 server address
2001:1::3.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] ipv6 dhcp select relay
[Sysname-Vlan-interface2] ipv6 dhcp relay server-address 2001:1::3
Related commands
display ipv6 dhcp relay server-address
ipv6 dhcp select

remote-server

Use remote-server to specify DHCPv6 servers for a DHCPv6 address pool.
Use undo remote-server to remove DHCPv6 servers from a DHCPv6 address pool.
Syntax
remote-server ipv6-address [ interface interface-type interface-number ]
undo remote-server [ ipv6-address [ interface interface-type interface-number ] ]
Default
No DHCPv6 server is specified for the DHCPv6 address pool.
Views
DHCPv6 address pool view
Predefined user roles
network-admin
Parameters
ipv6-address: Specifies a DHCPv6 server address.
interface interface-type interface-number: Specifies the outgoing interface by its type and number
for the DHCPv6 relay agent to forward packets to the DHCPv6 server. If you do not specify an
outgoing interface, the DHCPv6 relay agent performs a routing table lookup.
Usage guidelines
You can specify a maximum of eight DHCPv6 servers in one DHCPv6 address pool.
If you do not specify any parameters, the undo remote-server command removes all DHCPv6
servers in the DHCPv6 address pool.
If a DHCPv6 server address is a link-local address, you must specify an outgoing interface by using
the interface keyword in this command. If you do not specify an outgoing interface, DHCPv6 packets
might fail to reach the DHCPv6 server.
Examples
# Specify DHCPv6 server 10::1 for DHCPv6 address pool 0.
<Sysname> system-view
[Sysname] ipv6 dhcp pool 0
309