HPE FlexFabric 5950 Series Command Reference Manual page 344

Field
# Display brief information about Tunnel 1.
<Sysname> display interface tunnel 1 brief
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
Tun1
# Display brief information about Tunnel 1, including the complete interface description.
<Sysname> display interface tunnel 1 brief description
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
Tun1
Aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
# Display information about interfaces in DOWN state and the causes.
<Sysname> display interface tunnel brief down
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Interface
Tun0
Tun1
Table 74 Command output
Field
Interface
Link
Protocol
Primary IP
Description
Cause
Description
software.
Link Protocol Primary IP
UP UP 1.1.1.1
Link Protocol Primary IP
UP UP 1.1.1.1
Link Cause
DOWN Not connected
DOWN Not connected
Description
Abbreviated interface name.
Physical link state of the interface:
•
UP—The interface is physically up.
•
DOWN—The interface is physically down.
•
ADM—The interface has been shut down by using the shutdown
command. To restore the physical state of the interface, use the undo
shutdown command.
•
Stby—The interface is a backup interface in standby state. To see the
primary interface, use the display interface-backup state command.
Data link layer protocol state of the interface:
•
UP—The data link layer protocol of the interface is up.
•
DOWN—The data link layer protocol of the interface is down.
•
UP(s)—The data link layer protocol of the interface is up, but the link is
an on-demand link or does not exist. The (s) attribute represents the
spoofing flag. This value is typical of null interfaces and loopback
interfaces.
Primary IP address of the interface. This field displays two hyphens (--) if
the interface does not have an IP address.
Description of the interface.
Cause for the physical link state of an interface to be DOWN:
•
Administratively—The interface has been manually shut down by
334
Description
aaaaaaaaaaaaaaaaaaaaaaaaaaa
Description
aaaaaaaaaaaaaaaaaaaaaaaaaaaaa