Configuring Rip Route Redistribution - HP 5500 EI series Configuration Manual

# Display the RIP routing table on Router B.
[RouterB] display rip 1 route
Route Flags: R - RIP
----------------------------------------------------------------------------
Peer 1.1.1.1 on Ethernet1/1

Configuring RIP route redistribution

Network requirements
As shown in
RIP 200.
Configure RIP 200 to redistribute direct routes and routes from RIP 100 on Router B so Router C can learn
routes destined for 10.2.1.0/24 and 1 1.1.1.0/24. Router A cannot learn routes destined for 12.3.1.0/24
and 16.4.1.0/24.
Figure 8 Network diagram
Configuration procedure
Configure IP addresses for interfaces. (Details not shown.)
1.
2. Configure basic RIP:
# Enable RIP 100, and configure RIPv2 on Router A.
<RouterA> system-view
[RouterA] rip 100
[RouterA-rip-100] network 10.0.0.0
[RouterA-rip-100] network 11.0.0.0
[RouterA-rip-100] version 2
[RouterA-rip-100] undo summary
[RouterA-rip-100] quit
# Enable RIP 100 and RIP 200, and configure RIPv2 on Router B.
<RouterB> system-view
[RouterB] rip 100
[RouterB-rip-100] network 11.0.0.0
[RouterB-rip-100] version 2
[RouterB-rip-100] undo summary
2.1.1.0/24
3.1.1.0/24
A - Aging, S - Suppressed, G - Garbage-collect
O - Optimal, F - Flush to RIB
Destination/Mask
2.1.1.0/24
Figure 8, Router B communicates with Router A through RIP 100 and with Router C through
1.1.1.1 1
1.1.1.1 1
Nexthop Cost
1.1.1.1 1
40
0 RAOF 19
0 RAOF 19
Tag Flags Sec
0 RAOF 19