HP 5500 EI series Configuration Manual page 26

Verifying the configuration
# Display BFD sessions on Router A.
<RouterA> display bfd session
Total Session Num: 1
IPv4 Session Working Under Ctrl Mode:
LD/RD
4/7
The output shows that the BFD session has been created.
# Display static routes on Router A.
<RouterA> display ip routing-table protocol static
Summary Count : 1
Static Routing table Status : <Active>
Summary Count : 1
Destination/Mask
120.1.1.0/24
Static Routing table Status : <Inactive>
Summary Count : 0
The output shows that Router A communicates with Router B through Ethernet 1/1. Then the link over
Ethernet 1/1 fails.
# Display static routes on Router A.
<RouterA> display ip routing-table protocol static
Summary Count : 1
Static Routing table Status : <Active>
Summary Count : 1
Destination/Mask
120.1.1.0/24
Static Routing table Status : <Inactive>
Summary Count : 0
The output shows that Router A communicates with Router B through Ethernet 1/2.
Up Session Num: 1
SourceAddr DestAddr
12.1.1.1 12.1.1.2
Proto Pre Cost
Static 60 0
Proto Pre Cost
Static 65 0
Init Mode: Active
State
Up
NextHop
12.1.1.2
NextHop
10.1.1.100
15
Holdtime Interface
2000ms Eth1/1
Interface
Eth1/1
Interface
Eth1/2