Configuring Ospfv3 Ipsec Profiles - HP 5500 EI series Configuration Manual

<RouterA> display bfd session
Total Session Num: 1
IPv6 Session Working Under Ctrl Mode:
Local Discr: 1441
Source IP: FE80::20F:FF:FE00:1202 (link-local address of Ethernet1/1 on Router
A)
Destination IP: FE80::20F:FF:FE00:1200 (link-local address of Ethernet1/1 on Router
B)
Session State: Up
Hold Time: 2319ms
# Display routes destined for 2001:4::0/64 on Router A.
<RouterA> display ipv6 routing-table 2001:4::0 64
Summary Count : 1
Destination: 2001:4::/64
NextHop
Interface
The output shows that Router A communicates with Router B through Ethernet 1/1. Then the link over
Ethernet 1/1 fails.
# Display routes destined for 2001:4::0/64 on Router A.
<RouterA> display ipv6 routing-table 2001:4::0 64
Summary Count : 1
Destination: 2001:4::/64
NextHop
Interface
The output shows that Router A communicates with Router B through Ethernet 1/2.

Configuring OSPFv3 IPsec profiles

Network requirements
As shown in
Configure IPsec profiles on the routers to authenticate and encrypt protocol packets.
Up Session Num: 1
: FE80::20F:FF:FE00:1200
: Eth1/1
: FE80::BAAF:67FF:FE27:DCD0
: Eth1/2
Figure 91, all routers run OSPFv3, and the AS is divided into two areas.
Init Mode: Active
Remote Discr: 1450
Interface: Eth1/1
367
Protocol : OSPFv3
Preference: 10
Cost : 1
Protocol : OSPFv3
Preference: 10
Cost : 2