Configuring Ipv6 Static Routing; Configuring An Ipv6 Static Route - HP 5500 EI series Configuration Manual

Hide thumbs Also See for 5500 EI series:
Table of Contents

Advertisement

Configuring IPv6 static routing

Static routes are manually configured and cannot adapt to network topology changes. If a fault or a
topological change occurs in the network, the network administrator must modify the static routes
manually. IPv6 static routing works well in a simple IPv6 network.

Configuring an IPv6 static route

Before you configure an IPv6 static route, complete the following tasks:
Configure parameters for the related interfaces.
Configure link layer attributes for the related interfaces.
Ensure that the neighboring nodes can reach each other.
To configure an IPv6 static route:
Step
1.
Enter system view.
2.
Configure an IPv6 static
route.
3.
(Optional.) Configure the
default preference for IPv6
static routes.
4.
(Optional.) Delete all IPv6
static routes, including the
default route.
Command
system-view
Method 1:
ipv6 route-static ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | next-hop-address |
vpn-instance d-vpn-instance-name
next-hop-address } [ permanent ] [ preference
preference-value ] [ tag tag-value ]
[ description description-text ]
Method 2:
ipv6 route-static vpn-instance
s-vpn-instance-name ipv6-address
prefix-length { interface-type interface-number
[ next-hop-address ] | next-hop-address
[ public ] | vpn-instance d-vpn-instance-name
next-hop-address } [ permanent ] [ preference
preference-value ] [ tag tag-value ]
[ description description-text ]
ipv6 route-static default-preference
default-preference-value
delete ipv6 [ vpn-instance vpn-instance-name ]
static-routes all
310
Remarks
N/A
Use either method.
By default, no IPv6 static
route is configured.
The default setting is 60.
The undo ipv6
route-static command
deletes one IPv6 static
route.

Advertisement

Table of Contents
loading

This manual is also suitable for:

5500 si series

Table of Contents