Ripng Configuration Examples; Basic Ripng Configuration Example - HP 5500 EI series Configuration Manual

Hide thumbs Also See for 5500 EI series:
Table of Contents

Advertisement

Task
Reset a RIPng process.
Clear statistics of a RIPng process.

RIPng configuration examples

Basic RIPng configuration example

Network requirements
As shown in
filter the route (2::/64) learned from Router A, which means the route will not be added to the routing
table of Router B, and Router B forwards only the route 4::/64 to Router A.
Figure 83 Network diagram
Configuration procedure
1.
Configure IPv6 addresses for interfaces. (Details not shown.)
2.
Configure basic RIPng:
# Configure Router A.
<RouterA> system-view
[RouterA] ripng 1
[RouterA-ripng-1] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] ripng 1 enable
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] ripng 1 enable
[RouterA-Ethernet1/2] quit
# Configure Router B.
<RouterB> system-view
[RouterB] ripng 1
[RouterB-ripng-1] quit
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] ripng 1 enable
[RouterB-Ethernet1/1] quit
[RouterB] interface ethernet 1/2
[RouterB-Ethernet1/2] ripng 1 enable
[RouterB-Ethernet1/2] quit
Figure
83, all routers learn IPv6 routing information through RIPng. Configure Router B to
Command
reset ripng process-id process
reset ripng process-id statistics
330

Advertisement

Table of Contents
loading

This manual is also suitable for:

5500 si series

Table of Contents