Troubleshooting Ospf Configuration; No Ospf Neighbor Relationship Established; Incorrect Routing Information - HP 5500 EI series Configuration Manual

Hide thumbs Also See for 5500 EI series:
Table of Contents

Advertisement

[RouterD] display ip routing-table 1.1.1.1 verbose
Summary Count : 1
Destination: 1.1.1.1/32
Protocol: OSPF
SubProtID: 0x1
Cost: 1
Tag: 0
OrigTblID: 0x0
TableID: 0x2
NBRID: 0x26000002
AttrID: 0xffffffff
Flags: 0x1008c
Label: NULL
BkLabel: NULL
Tunnel ID: Invalid
BkTunnel ID: Invalid

Troubleshooting OSPF configuration

No OSPF neighbor relationship established

Symptom
No OSPF neighbor relationship can be established.
Analysis
If the physical link and lower layer protocols work well, verify OSPF parameters configured on interfaces.
Two neighbors must have the same parameters, such as the area ID, network segment, and mask (a P2P
or virtual link can have different network segments and masks).
Solution
1.
Use the display ospf peer command to verify OSPF neighbor information.
2.
Use the display ospf interface command to verify OSPF interface information.
3.
Ping the neighbor router's IP address to verify that the connectivity is normal.
4.
Verify OSPF timers. The dead interval on an interface must be at least four times the hello interval.
5.
On an NBMA network, use the peer ip-address command to manually specify the neighbor.
6.
At least one interface must have a router priority higher than 0 on an NBMA or a broadcast
network.

Incorrect routing information

Symptom
OSPF cannot find routes to other areas.
Process ID: 1
Age: 04h20m37s
Preference: 10
State: Active Adv
OrigVrf: default-vrf
OrigAs: 0
LastAs: 0
Neighbor: 0.0.0.0
OrigNextHop: 13.13.13.1
RealNextHop: 13.13.13.1
BkNextHop: 24.24.24.2
Interface: Ethernet1/2
BkInterface: Ethernet1/1
120

Advertisement

Table of Contents
loading

This manual is also suitable for:

5500 si series

Table of Contents