Protocols And Standards; Ripng Configuration Task List; Configuring Basic Ripng - HP 5500 EI series Configuration Manual

Hide thumbs Also See for 5500 EI series:
Table of Contents

Advertisement

2.
When a RIPng neighbor receives the request packet, it sends back a response packet that contains
the local routing table. RIPng can also advertise route updates in response packets periodically or
advertise a triggered update caused by a route change.
3.
After RIPng receives the response, it checks the validity of the response before adding routes to its
routing table, such as whether the source IPv6 address is the link-local address and whether the
port number is correct. A response packet that fails the check is discarded.

Protocols and standards

RFC 2080, RIPng for IPv6
RFC 2081, RIPng Protocol Applicability Statement

RIPng configuration task list

Tasks at a glance
(Required.)
(Optional.)
Configuring an additional routing metric
Configuring RIPng route summarization
Advertising a default route
Configuring received/redistributed route filtering
Configuring a preference for RIPng
Configuring RIPng route redistribution
(Optional.)
Configuring RIPng timers
Configuring split horizon and poison reverse
Configuring zero field check on RIPng packets
Configuring the maximum number of ECMP routes
(Optional.)
(Optional.)

Configuring basic RIPng

Before you configure basic RIPng, configure IPv6 addresses for interfaces to ensure IPv6 connectivity
between neighboring nodes.
To configure basic RIPng:
Step
1.
Enter system view.
2.
Create a RIPng process and
enter its view.
Configuring basic RIPng
Configuring RIPng route
Tuning and optimizing the RIPng
Configuring RIPng GR
Applying an IPsec profile
control:
network:
Command
system-view
ripng [ process-id ]
[ vpn-instance
vpn-instance-name ]
323
Remarks
N/A
By default, the RIPng process is not
created.

Advertisement

Table of Contents
loading

This manual is also suitable for:

5500 si series

Table of Contents