HP 5500 EI series Configuration Manual page 107

[RouterB] ospf
[RouterB-ospf-1] area 0
[RouterB-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.0] quit
[RouterB-ospf-1] area 2
[RouterB-ospf-1-area-0.0.0.2] network 10.3.1.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.2] quit
[RouterB-ospf-1] quit
# Configure Router C.
<RouterC> system-view
[RouterC] router id 10.4.1.1
[RouterC] ospf
[RouterC-ospf-1] area 1
[RouterC-ospf-1-area-0.0.0.1] network 10.2.1.0 0.0.0.255
[RouterC-ospf-1-area-0.0.0.1] network 10.4.1.0 0.0.0.255
[RouterC-ospf-1-area-0.0.0.1] quit
[RouterC-ospf-1] quit
# Configure Router D.
<RouterD> system-view
[RouterD] router id 10.5.1.1
[RouterD] ospf
[RouterD-ospf-1] area 2
[RouterD-ospf-1-area-0.0.0.2] network 10.3.1.0 0.0.0.255
[RouterD-ospf-1-area-0.0.0.2] network 10.5.1.0 0.0.0.255
[RouterD-ospf-1-area-0.0.0.2] quit
[RouterD-ospf-1] quit
Verifying the configuration
# Display the OSPF neighbors of Router A.
[RouterA] display ospf peer verbose
Area 0.0.0.0 interface 10.1.1.1(Ethernet1/1)'s neighbors
Router ID: 10.3.1.1
State: Full
DR: 10.1.1.1
Options is 0x02 (-|-|-|-|-|-|E|-)
Dead timer due in 37
Neighbor is up for 06:03:59
Authentication Sequence: [ 0 ]
Neighbor state change count: 5
Area 0.0.0.1 interface 10.2.1.1(Ethernet1/2)'s neighbors
Router ID: 10.4.1.1
State: Full
OSPF Process 1 with Router ID 10.2.1.1
Neighbors
Mode: Nbr is Master
BDR: 10.1.1.2
sec
Neighbors
Mode: Nbr is Master
Address: 10.1.1.2
Priority: 1
MTU: 0
Address: 10.2.1.2
Priority: 1
96
GR State: Normal
GR State: Normal