Is-Is Route Redistribution Configuration Example - HP 5500 EI series Configuration Manual

Hide thumbs Also See for 5500 EI series:
Table of Contents

Advertisement

Interface: Ethernet1/1
State: Up
System Id: 0000.0000.0002
Interface: Ethernet1/1
State: Up
[RouterD] display isis interface
Interface: Ethernet1/1
Id
001

IS-IS route redistribution configuration example

Network requirements
As shown in
to interconnect. Router A and Router B are Level- 1 routers, Router D is a Level-2 router, and Router C is a
Level- 1 -2 router.
Redistribute RIP routes into IS-IS on Router D.
Figure 42 Network diagram
Configuration procedure
1.
Configure IP addresses for interfaces. (Details not shown.)
2.
Configure basic IS-IS:
# Configure Router A.
<RouterA> system-view
[RouterA] isis 1
[RouterA-isis-1] is-level level-1
[RouterA-isis-1] network-entity 10.0000.0000.0001.00
[RouterA-isis-1] quit
HoldTime: 7s
HoldTime: 26s
Interface information for IS-IS(1)
---------------------------------
IPv4.State
Up
Figure
42, Router A, Router B, Router C, and Router D reside in the same AS. They use IS-IS
Circuit Id: 0000.0000.0001.01
Type: L2
Circuit Id: 0000.0000.0001.01
Type: L2
IPv6.State
MTU
Down
1497
161
PRI: 100
PRI: 64
Type
DIS
L1/L2
No/No

Advertisement

Table of Contents
loading

This manual is also suitable for:

5500 si series

Table of Contents