HP 5500 EI series Configuration Manual page 264

Hide thumbs Also See for 5500 EI series:
Table of Contents

Advertisement

Figure 63 Network diagram
Loop0
1.1.1.1/32
Eth1/1
8.1.1.1/24
Router A
Configuration considerations
Configure BGP to redistribute routes from OSPF on Router B, so Router A can obtain the route to
9.1.2.0/24. Configure OSPF to redistribute routes from BGP on Router B, so that Router C can obtain the
route to 8.1.1.0/24.
Configuration procedure
1.
Configure IP addresses for interfaces. (Details not shown.)
2.
Configure OSPF:
Enable OSPF in AS 65009, so Router B can obtain the route to 9.1.2.0/24.
# Configure Router B.
<RouterB> system-view
[RouterB] ospf 1
[RouterB-ospf-1] area 0
[RouterB-ospf-1-area-0.0.0.0] network 2.2.2.2 0.0.0.0
[RouterB-ospf-1-area-0.0.0.0] network 9.1.1.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.0] quit
[RouterB-ospf-1] quit
# Configure Router C.
<RouterC> system-view
[RouterC] ospf 1
[RouterC-ospf-1] import-route direct
[RouterC-ospf-1] area 0
[RouterC-ospf-1-area-0.0.0.0] network 9.1.1.0 0.0.0.255
[RouterC-ospf-1-area-0.0.0.0] quit
[RouterC-ospf-1] quit
3.
Configure the EBGP connection:
Configure the EBGP connection and inject network 8.1.1.0/24 to the BGP routing table of Router
A, so Router B can obtain the route to 8.1.1.0/24.
# Configure Router A.
<RouterA> system-view
[RouterA] bgp 65008
[RouterA-bgp] router-id 1.1.1.1
[RouterA-bgp] peer 3.1.1.1 as-number 65009
[RouterA-bgp] address-family ipv4 unicast
[RouterA-bgp-ipv4] peer 3.1.1.1 enable
[RouterA-bgp-ipv4] network 8.1.1.0 24
[RouterA-bgp-ipv4] quit
[RouterA-bgp] quit
AS 65009
AS 65008
2.2.2.2/32
EBGP
Eth1/2
Eth1/1
3.1.1.2/24
3.1.1.1/24
Router B
Loop0
OSPF
Eth1/2
Eth1/1
9.1.1.1/24
9.1.1.2/24
253
Loop0
3.3.3.3/32
Eth1/2
9.1.2.1/24
Router C

Advertisement

Table of Contents
loading

This manual is also suitable for:

5500 si series

Table of Contents