HP 5500 EI series Configuration Manual page 243

Hide thumbs Also See for 5500 EI series:
Table of Contents

Advertisement

Step
2.
Enter BGP view or BGP-VPN
instance view.
3.
Enable BGP route refresh for a
peer or peer group.
Saving updates
To save all route updates from the specified peer or peer group (IPv4):
Step
1.
Enter system view.
2.
Enter BGP view or BGP-VPN
instance view.
3.
Enter BGP IPv4 unicast
address family view or
BGP-VPN IPv4 unicast
address family view.
4.
Save all route updates from
the peer or peer group.
To save all route updates from the specified peer or peer group (IPv6):
Step
1.
Enter system view.
2.
Enter BGP view
Command
Enter BGP view:
bgp as-number
Enter BGP-VPN instance view:
a.
bgp as-number
b.
ip vpn-instance
vpn-instance-name
Enable BGP route refresh for the
specified peer or peer group:
peer { group-name |
ipv6-address }
capability-advertise
route-refresh
Enable BGP route refresh and
multi-protocol extension
capability for the specified peer
or peer group:
undo peer { group-name |
ipv6-address }
capability-advertise
conventional
Command
system-view
Enter BGP view:
bgp as-number
Enter BGP-VPN instance view:
a.
bgp as-number
b.
ip vpn-instance
vpn-instance-name
address-family ipv4 [ unicast ]
peer { group-name | ip-address }
keep-all-routes
Command
system-view
bgp as-number
232
Remarks
N/A
Use either method.
By default, BGP route refresh is
enabled.
Remarks
N/A
N/A
N/A
By default, the routes are not
saved.
This command takes effect only for
the routes received after this
command is executed.
Remarks
N/A
N/A

Advertisement

Table of Contents
loading

This manual is also suitable for:

5500 si series

Table of Contents