Configuring An Aggregate Interface; Configuring The Description Of An Aggregate Interface; Enabling Link State Traps For An Aggregate Interface - HP 6125G Configuration Manual

Configuring an aggregate interface

Most of the configurations that can be performed on Layer 2 Ethernet interfaces can also be performed
on Layer 2 aggregate interfaces.

Configuring the description of an aggregate interface

You can configure the description of an aggregate interface for administration purposes such as
describing the purpose of the interface.
To configure the description of an aggregate interface:
Step
1. Enter system view.
2. Enter Layer 2 aggregate
interface view.
3. Configure the description
of the aggregate interface.

Enabling link state traps for an aggregate interface

You can configure an aggregate interface to generate linkUp trap messages when its link goes up and
linkDown trap messages when its link goes down. For more information, see Network Management and
Monitoring Configuration Guide.
To enable link state traps on an aggregate interface:
Step
1. Enter system view.
2. Enable the trap function
globally.
3. Enter Layer 2 aggregate
interface view.
4. Enable link state traps for the
aggregate interface.
Command
system-view
interface bridge-aggregation
interface-number
description text
Command
system-view
snmp-agent trap enable [ standard
[ linkdown | linkup ] * ]
interface bridge-aggregation
interface-number
enable snmp trap updown
38
Remarks
N/A
Use either command.
Optional
By default, the description of an
interface is in the format of
interface-name Interface, such as
Bridge-Aggregation1 Interface.
Remarks
N/A
Optional
By default, link state trapping is
enabled globally and on all
interfaces.
Use either command.
Optional.
Enabled by default.