Protocol-Based Vlan Configuration Example - HP 6125G Configuration Manual

Step
1. Enter system view.
2. Enter VLAN view.
Create a protocol
3.
template for the
VLAN.
4. Exit VLAN view.
5. Enter interface
view.
6. Configure the port
link type as hybrid.
7. Assign the hybrid
port to the
specified
protocol-based
VLANs.
8. Assign the protocol
template you have
created to the
hybrid port.

Protocol-based VLAN configuration example

Network requirements
In a lab environment, as shown in
run the IPv6 protocol for teaching purposes. To avoid interference, isolate IPv4 traffic and IPv6 traffic at
Layer 2.
Command
system-view
vlan vlan-id
protocol-vlan [ protocol-index ] { at
| ipv4 | ipv6 | ipx { ethernetii | llc
| raw | snap } | mode { ethernetii
etype etype-id | llc { dsap dsap-id
[ ssap ssap-id ] | ssap ssap-id } |
snap etype etype-id } }
quit
•
Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
•
Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
port link-type hybrid
port hybrid vlan vlan-list { tagged |
untagged }
port hybrid protocol-vlan vlan
vlan-id { protocol-index [ to
protocol-end ] | all }
Figure 36, most hosts run the IPv4 protocol, and the rest of the hosts
118
Remarks
N/A
If the specified VLAN does not exist, this
command creates the VLAN first.
Not configured by default.
N/A
Use any command.
•
The configuration made in Ethernet
interface view applies only to the port.
•
The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply
the configuration to the aggregate
interface, it stops applying the
configuration to aggregation member
ports. If the system fails to apply the
configuration to an aggregation member
port, it skips the port and moves to the
next member port.
By default, all ports are access ports.
By default, a hybrid port is only in VLAN 1.
N/A