Assigning A Vlan Trunk Port - HP A5830 Configuration Manual

Step...
2. Enter
interface
view or
port
group
view
3. Configure the link type of
the ports as access
4. Assign the access ports to a
VLAN

Assigning a VLAN trunk port

A trunk port can carry multiple VLANs. Assign a trunk port to a VLAN in interface view (including Layer 2
Ethernet interface view, and Layer 2 aggregate interface view) or port group view.
To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to access
first.
After configuring the PVID for a trunk port, you must use the port trunk permit vlan command to configure
the trunk port to allow packets from the PVID to pass through, so that the egress port can forward packets
from the PVID.
To assign a trunk port to one or multiple VLANs:
Step...
1. Enter system view
2. Enter
interface
view or
port group
view
Command...
Enter Layer 2 interface interface-
Ethernet type interface-
interface view number
Enter Layer 2 interface bridge-
aggregate aggregation
interface view interface-number
Enter port port-group manual
group view port-group-name
port link-type
access
port access vlan
vlan-id
Command...
system-view
Enter Layer 2
interface interface-
Ethernet
type interface-number
interface view
Enter Layer 2 interface bridge-
aggregate aggregation interface-
interface view number
Remarks
Required.
Use any command:

The configuration made in Layer 2 Ethernet
interface view only applies to the port.

The configuration made in port group view
applies to all ports in the port group.

The configuration made in Layer 2 aggregate
interface view applies to the aggregate interface
and its aggregation member ports. If the system
fails to apply the configuration to the aggregate
interface, it stops applying the configuration to
aggregation member ports. If the system fails to
apply the configuration to an aggregation
member port, it skips the port and moves to the
next member port.
Optional.
By default, all ports are access ports.
Optional.
By default, all access ports belong to VLAN 1.
Remarks
—
Required.
Use any command:

The configuration made in Layer 2 Ethernet
interface view only applies to the port.

The configuration made in port group view
109