Assigning A Trunk Port To A Vlan - HP 5820X series Configuration Manual

To do...
Enter VLAN view
2.
3. Assign one or a group of
access ports to the current
VLAN
To assign an access port (in interface view) or multiple access ports (in port group view) to a VLAN:
To do...
1. Enter system view
2. Enter interface
view
(including
Ethernet
interface view,
Layer 2
aggregate
interface view)
or port group
view
3. Configure the link type of the
port or ports as access
4. Assign the current access ports to
a VLAN
Before assigning an access port to a VLAN, create the VLAN first.
In VLAN view, only Layer 2 Ethernet interfaces can be assigned to the current VLAN.
After you configure a command on a Layer 2 aggregate interface, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do that
on the aggregate interface, it stops applying the configuration to the aggregation member ports. If it fails
to do that on an aggregation member port, it skips the port and moves to the next port.

Assigning a trunk port to a VLAN

A trunk port can carry multiple VLANs. Assign it to a VLAN in interface view (including Ethernet interface
view, Layer 2 aggregate interface view) or port group view.
To assign a trunk port to one or multiple VLANs:
Use the command...
vlan vlan-id
port interface-list
Use the command...
system-view
Enter Ethernet interface interface-type
interface view interface-number
Enter Layer 2
interface bridge-aggregation
aggregate
interface-number
interface view
Enter port port-group manual port-group-
group view name
port link-type access
port access vlan vlan-id
Remarks
Required.
If the specified VLAN does not exist, this
command creates the VLAN first.
Required.
By default, all ports belong to VLAN 1.
109
Remarks
—
Required.
Use either command.
•
In Ethernet interface view, the
subsequent configurations
apply to the current port.
• In port group view, the
subsequent configurations
apply to all ports in the port
group.
•
In Layer 2 aggregate interface
view, the subsequent
configurations apply to the
Layer 2 aggregate interface
and all its member ports.
Optional.
The link type of a port is access
by default.
Optional.
By default, all access ports
belong to VLAN 1.