Xconfiguration Video Input Connector [1; Xconfiguration Video Input Connector [2] Presentationselection - Cisco TelePresence DX70 Reference Manual

Cisco TelePresence DX70 and DX80

Introduction
xConfiguration Video Input Connector [1..2] Name
Define a name for the video input connector.
Requires user role: ADMIN, INTEGRATOR
Default value: ""
USAGE:
xConfiguration Video Input Connector
where
n
: Unique ID that identifies the video input connector. Range: 1..2
Name
: String (0, 50)
Name for the video input connector.
D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration xConfiguration
n Name: "Name"
xCommand

xConfiguration Video Input Connector [2] PresentationSelection

Define how the video system will behave when you connect a presentation source to the video
input.
If the video system is in standby mode, it will wake up when you connect a presentation source.
Sharing the presentation with the far end requires additional action (select Share on the user
interface) except when this setting is set to AutoShare.
Requires user role: ADMIN, INTEGRATOR
Default value: Desktop
USAGE:
xConfiguration Video Input Connector
PresentationSelection
where
n
: Unique ID that identifies the video input connector. Range: 2..2
PresentationSelection
: AutoShare/Desktop/Manual/OnConnect
AutoShare: While in a call, the content on the video input will automatically be presented
to the far end as well as on the local screen when you connect the cable, or when the
source is activated otherwise (for example when a connected computer wakes up from
sleep mode). You do not have to select Share on the user interface. If a presentation
source is already connected when you make or answer a call, you have to manually
select Share on the user interface.
Desktop: The content on the video input will be presented on the screen when you
connect the cable, or when the source is activated otherwise (for example when a
connected computer wakes up from sleep mode). This applies both when idle and in a
call. Also, the content on the video input will stay on the screen when you leave the call,
provided that it was the active input at the time of leaving.
Manual: The content on the video input will not be presented on the screen until you
select Share from the user interface.
OnConnect: The content on the video input will be presented on screen when you
connect the cable, or when the source is activated otherwise (for example when a
connected computer wakes up from sleep mode). Otherwise, the behavior is the same
as in manual mode.
85
API Reference Guide
xStatus Appendices
n PresentationSelection:
Copyright © 2017 Cisco Systems, Inc. All rights reserved.