Cisco TelePresence SX20 Codec
Introduction
xCommand UserManagement User Passphrase Set
Set a user passphrase for the specified user. You must be logged in as an administrator to set a
user passphrase.
Requires user role: ADMIN
USAGE:
xCommand UserManagement User Passphrase Set NewPassphrase: "NewPassphrase"
Username: "Username" YourPassphrase: "YourPassphrase"
where
NewPassphrase: String (0, 255)
Username: String (0, 127)
YourPassphrase: String (0, 255)
SX20 Codec API Reference Guide CE8.1, APRIL 2016.
D15316.03
About the API
xConfiguration
xCommand
xCommand
Video commands
xCommand Video ActiveSpeakerPIP Set
Sets position for the active speakers PiP (picture in picture).
Requires user role: ADMIN, USER
USAGE:
xCommand Video ActiveSpeakerPIP Set Position:
where
Position: CenterLeft/CenterRight/LowerLeft/LowerRight/UpperCenter/UpperLeft/UpperRight
Select one of the predefined positions.
xCommand Video Input SetMainVideoSource
Set which input source is the main video source. You can identify the source either by the
identifier of the connector that it is connected to; or by the identifier of the source itself.
This command requires the use of one, and only one, of these parameters: ConnectorId or
SourceId.
Requires user role: ADMIN, USER
USAGE:
xCommand Video Input SetMainVideoSource [ConnectorId: ConnectorId] [SourceId:
SourceId]
where
ConnectorId: Integer (1..3)
The identifier (ID) of the connector. Connector [n] has ID n. Run the following API
command to find the ID: xStatus Video Input Connector. The connector ID is also printed
on the codec connector panel.
SourceId: Integer (1..3)
The identifier (ID) of the input source. Input Source [n] has ID n. Run the following API
command to find the ID: xStatus Video Input Source.
125
API Reference Guide
xStatus
Appendices
Position
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
Need help?
Do you have a question about the TelePresence SX20 Codec and is the answer not in the manual?
Questions and answers