6.4 Trend Mode
6.4.1 Programming and Starting a Recording
The ON/OFF light will blink when the recording is in progress. When the
recording is done, the ON/OFF light will turn off. You will need to press it
again to restart the instrument.
This mode enables all the parameters previously configured in the Configuration
mode
to be recorded (see § 4.3).
1.
Press the Trend mode button -
1.
Select the Configuration that was previously set-up (see § 4.3) by using the ▲
or ▼ button to highlight Set-up, then press the
2.
Use the ▲ or ▼ button to choose Configuration 1, 2 3 or 4, then press
3.
Select the Start field using the ▼ button. Press
field, then use the appropriate arrow buttons to change the date and time.
Press
when finished.
4.
Using the same method as steps 1, 2 and 3, use the arrow buttons and the
button to change the values for Stop, Period and Name.
5.
Press the OK icon's yellow button to begin recording between your specified
start and end times. The OK icon disappears and the icon
Power Quality Analyzer Model 8335
.
Figure 6-13
button.
to select the date and time
appears.
.
65