Harmonic MediaGrid Installation And Configuration Manual page 87

Chapter 3 System Installation with the Content-
Server 3000 Series

NOTE: Once you have completed the network connections, group the cables and then secure them to the
rear side rails.
2. Using SAS cables, connect each ContentStore to the ContentServer.
Refer to

ContentServer 3000 to the ContentStore
3. Connect the Harmonic MediaGrid network switch to the client network.
Refer to

Network Switches to the Client Network: Two-rack
4. Connect power cables to each system component.

IMPORTANT: After connecting power cables, do not power on the system. You must configure the
network switches first. Refer to
Harmonic MediaGrid system.
Network Switch Connections
Figure 3–18 and
network and a 1 GbE network. Not all connections are shown. See the instructions following the
illustration for each device's specific port connections.
IMPORTANT: Make sure to use only Harmonic MediaGrid-qualified switches in your Harmonic MediaGrid
system. To find out if a switch is Harmonic MediaGrid-qualified, contact your Harmonic representative.
NOTE: The switches shown in this section are example only. Your switch may vary from those shown.
© 2017 Harmonic Inc. All rights reserved.
Refer to Connecting the High Bandwidth ContentBridge to the Network
ContentBridge 1000B to the Network
to Connecting High Bandwidth ContentBridges in a High Availability (HA)
Connecting the ContentServer 3000 to ContentStore(s) 3160
Connecting Network Switches to the Client Network: One-rack System
Connecting the Power Cables in a System with ContentServer 3000
Refer to
Chapter 4, System Configuration
Figure 3–19 provide an overview of network switch connections for a 10 GbE
Connecting the Harmonic MediaGrid 3000 System Components
Switch, or if configuring a High Availability pair, refer
5840.
System, depending on the system setup.
for instructions for configuring your
87
Switch, Connecting the
Pair.
Connecting the
or
or Connecting
Series.
Harmonic MediaGrid Release 4.1