Harmonic MediaGrid Installation And Configuration Manual page 253

Chapter 8 Hardware Reference
Table 8–31: ContentServer 4000 Rear Panel Components
3. Serial port
4. VGA port
5. BMC port
6. USB ports (2)
7. Mini SAS HD connectors (4)
8. 10 GbE NIC ports (4)
9. Onboard Mini SAS HD
connectors (2)
10 GbE Port Indicator
The ContentServer 4000 contains two dual-port10 GbE NIC cards. Each port has a single LED.
Figure 8–33: ContentServer 4000 10GbE Port LED
© 2017 Harmonic Inc. All rights reserved.
Item
Use to connect a serial device to the system.
Use to connect a monitor to the system (for maintenance
only).
Baseboard Management Console port (used for
troubleshooting purposes). Maximum data rate 100Mb/s
Used for maintenance purposes only.
Used for connecting the ContentServer to ContentStores.
Use for connecting the ContentServer to the network
switch




Currently unused.
253
Description
CAUTION: With Harmonic MediaGrid 4.0, SAS
cables are not hot-swappable. When replacing or
removing a SAS cable, you must first power
down the associated ContentServer controller
using SystemManager, replace or re-connect the
SAS cable, and then power on the ContentServer
controller by pressing the power button on the
front panel.
Upper right: NIC 2
Lower right: NIC 3
Upper left: NIC 4
Lower left: NIC 5
ContentServer 4000
Harmonic MediaGrid Release 4.1