Harmonic MediaGrid Installation And Configuration Manual page 301

Appendix A Legacy Hardware Platforms
Table A–4: Drive-status Indicator Pattern (RAID Only)
Drive-status Indicator Pattern
Blinks green two times per second
Off
Blinks green, amber, and off
Blinks amber four times per
second
Blinks green slowly
Steady green
Blinks green three seconds,
amber three seconds, and off six
seconds
Figure A–5
and
1
Figure A–5: Rear View of ContentDirector
Table A–5: ContenDirector Rear Panel Components
Indicator, Button, or Connector
1. Serial connector
2. Video connector
3. USB connectors (2)
4. NIC 0 connector
5. NIC 1 connector
6. NIC 2 connector
© 2017 Harmonic Inc. All rights reserved.
ContentDirector 1000B/1000C/1000D and High Performance ContentDirector 2000
Table A–5
describe the rear panel view of the ContentDirector.
4
2
3 5
Identify drive/preparing for removal
Drive ready for insertion or removal
Note
: The drive-status indicator remains off
until all hard drives are initialized after system
power is applied. Drives are not ready for
insertion or removal during this time.
Drive predicted failure
Drive failed
Drive rebuilding
Drive online
Rebuild aborted
7
6
8 9
Use to connect a serial device to the system
Use to connect a monitor to the system (for maintenance
only).
Used for maintenance purposes only.
Use for Gigabit Ethernet connection to switch.
Use for Gigabit Ethernet connection to switch.
Use for Gigabit Ethernet connection to switch.
301
Condition
10
11
Description
Harmonic MediaGrid Release 4.1