Harmonic MediaGrid Installation And Configuration Manual page 320

Appendix A Legacy Hardware Platforms
Table A–21: 10 Gigabit Ethernet LED Pattern
Indicator Pattern
Off
Green
Yellow (two short blinks)
Yellow (solid, continuous blinking)
Power Supply LEDs
Figure A–19 and
.
Figure A–19: ContentBridge 2010B/C/D Power Supply Indicators
Table A–22: Power Supply Indicator Pattern
Indicator Pattern
Not lit
Green
Amber
Alternating Green and Amber
IMPORTANT: Do not turn off power when replacing a drive. As soon as the new drive is inserted, the
system will begin replicating the data from the other drives.
© 2017 Harmonic Inc. All rights reserved.
Power off or network cables unplugged
Port enabled and receiving link indication
Network activity occurring
Some abnormal condition
Table A–22 describe the typical Power Supply Indicator and its functions.
Power supply status indicator
AC power is not connected.
In standby mode, indicates that a valid AC source is
connected to the power supply, and that the power
supply is operational. When the system is on, it also
indicates that the power supply is providing DC power to
the system.
Indicates a problem with the power supply.
When hot-adding a power supply, this indicates that the
power supply is mismatched with the other power supply
(a high output power supply and a Energy Smart power
supply are installed in the same system). To correct this,
replace the power supply that has the flashing indicator
with a power supply that matches the capacity of the
other installed power supply.
ContentBridge 2010B/C/D (High Bandwidth)
320
Condition
Condition
Harmonic MediaGrid Release 4.1