Harmonic MediaGrid Installation And Configuration Manual page 300

Appendix A Legacy Hardware Platforms
Table A–3: ContentDirector Front Panel Components
Indicator, Button, or Connector
1. Power-on indicator/button
2. Video Connector
3. LCD menu buttons
4. LCD display
5. System identification button
6. USB connectors
7. Optical drive
8. Hard drive 0
9. Hard drive 1
10. Solid state drive
Figure A–4 and
Drive-status Indicator (green and amber)
Drive-activity Indicator (green)
Figure A–4: ContentDirector Hard Drive Indicators
© 2017 Harmonic Inc. All rights reserved.
ContentDirector 1000B/1000C/1000D and High Performance ContentDirector 2000
Table A–4 describe the typical hard drive indicators and their functions.
The power button controls the DC power supply output
to the system.
The power-on indicator lights when the system power is
on. When the power-on indicator is off, this indicates that
no power is supplied to the system.
Connects a monitor to the system.
Allows you to navigate the control panel
LCD menu.
Provides status information and system error messages.
The LCD display lights during normal system operation.
Both the systems management software and the
identification buttons located on the front and back of the
system can cause the LCD to flash blue to identify a
particular system.
The LCD display lights amber when the system needs
attention due to a problem with power supplies, fans,
system temperature or hard drives.
Note: If the system is connected to AC power and an
error has been detected, the LCD display lights amber
regardless of whether the system has been powered on.
Pressing this button will cause the Front LCD display and
the system status indicator on the rear panel to blink.
Use to connect the front bezel.
Use for software installation.
Refer to Table A–4 for a description of the indicator codes.
Available only in the High Performance ContentDirector
2000.
300
Description
Harmonic MediaGrid Release 4.1