Harmonic MediaGrid Installation And Configuration Manual page 325

Appendix A Legacy Hardware Platforms
Figure 9–13: Rear View of ContentBridge 2010E
Table 9–14: ContentBridge 2010E Rear Panel Components
Indicator, Button, or Connector
1. Serial connector
2. Video connector
3. 10 Gigabit Ethernet LEDs
4. 10 Gigabit Ethernet connector
5. Gigabit Ethernet ports
6. USB connectors (2)
7. System identification button/
indicator
8. Power supply 1
9. Power supply 2
10 Gigabit Ethernet LEDs
Figure 9–14 and
© 2017 Harmonic Inc. All rights reserved.
3 4
2 5
1
Use to connect a serial device to the system
Use to connect a monitor to the system (for maintenance
only).
The LEDs show the state of the 10 Gigabit Ethernet
connector. For a description of the LEDs and possible
states, refer to
Use to connect the ContentBridge to the customer
network switch.
The Link light does not appear until the Configuration
Assistant is completed for the ContentBridge. Refer to
About Harmonic MediaGrid Configuration
information.
NIC 0 (left) and NIC 1 (right)
Used for maintenance purposes only.
Both the SystemManager application and the system
identification buttons on the front and back panels can be
used to locate a particular system within a rack. When
one of these buttons is pressed, the ID buttons on the
front and rear panels blink until one of the buttons is
pressed again.
Dual redundant power supplies provide power to the
system.
Table 9–15 describe the possible states of the 10 Gigabit Ethernet LEDs.
7
6
Description
Figure 9–14
325
ContentBridge 2010E
8 9
and Table 9–15.
for more
Harmonic MediaGrid Release 4.1