Harmonic MediaGrid Installation And Configuration Manual page 237

Chapter 8 Hardware Reference
Table 8–15: ContentBridge 2010F Rear Panel Components
Indicator, Button, or Connector
1 2. System ID LED
1 3. Baseboard Management
Console (BMC) Connector
10 Gigabit Ethernet LEDs
Figure 8–16 and
10 Gigabit Ethernet Indicator
Figure 8–16: 10 Gigabit Ethernet LEDs
Table 8–16: 10 Gigabit Ethernet LED Pattern
Indicator Pattern
Steady on
Blinking
Green
Yellow
1 Gigabit Ethernet LEDs
The 1 Gigabit NIC has a link/activity LED and a speed LED. Refer to
Figure 8–17: ContentBridge 2010F 1 Gigabit Ethernet LED Indicator
Codes
Link/Activity
Green (blink) = activity
Green (solid) = link
Off = no link
© 2017 Harmonic Inc. All rights reserved.
Table 8–16 describe the possible states of the 10 Gigabit Ethernet LEDs.
The NIC is connected to a valid network link.
The NIC is connected and network data is being sent or received.
Link speed is 10 Gbps.
Link speed is 1 Gbps.
Located on the back edge of the server board, this
LED matches the state of the System ID LED on the
front Control Panel. When that button is pushed, this
LED flashes blue until the button is pressed again.
Do not use.
Condition
Speed
Green = 1 Gbps
Yellow = 100 Mbps
Off = No link
237
ContentBridge 2010F
Description
Figure 8–17.
Harmonic MediaGrid Release 4.1