Harmonic MediaGrid Installation And Configuration Manual page 103

Chapter 3 System Installation with the Content-
Server 3000 Series
c. From the
the
d. Click
4. Connect one end of the SAS cable to the right-hand SAS port on the left-hand controller on
the last ContentStore in the daisy chain, and then connect the other end of the cable to the
left-hand SAS port on the left-hand controller on the new ContentStore. Refer to
an example.
5. Apply power to the new ContentStore by pressing the power button on the front panel.
6. Power on Controller 0 on the ContentServer by pressing the power button on the front panel.
Note that the right-hand controller, which is already powered on, will not be affected.
7. On the
Controller 0 changes to
8. Power down Controller 1 on the ContentServer by clicking the
OK
click
9. Connect one end of the SAS cable to the right-hand SAS port on the right-hand controller on
the last ContentStore in the daisy chain, and then connect the other end of the cable to the
left-hand SAS port on the right-hand controller on the new ContentStore.
10. Power on Controller 1 on the ContentServer by pressing the power button on the front panel.
1 1. On the
Controller 1 changes to
1 2. Add the new ContentStore to the associated group as follows:
a. From the
b. From the
click
c. Click
1 3. Navigate to the
ContentServer controllers.
© 2017 Harmonic Inc. All rights reserved.
Properties
page, scroll to the
Shutdown
button for Controller 0.
OK
to confirm.
ContentServer Properties
Connected
to confirm.
ContentServer Properties
Connected
Cluster Properties
Group Properties
Add Server(s) to this Group
OK
to confirm, and then click
ContentServer Properties
Expanding a Harmonic MediaGrid 3000 Series System
ContentServer Controllers
page in SystemManager, verify that the
.
page in SystemManager, verify that the
.
page, click the associated
page, select the device you wish to add to the group, and then
.
Done
.
page and click the
103
section and then click
Figure 3–27
Status
field for
Shutdown
button, and then
Status
field for
Group ID
.
Failback
button to balance the
Harmonic MediaGrid Release 4.1
for