Harmonic MediaGrid Installation And Configuration Manual page 67

Chapter 2 System Installation with the Content-
Server 4000 Series
7. On the
Controller 0 changes to
8. Power down the bottom controller by clicking the
OK
click
9. Connect one end of the SAS cable to an open SAS port on the bottom controller, and then
connect the other end of the cable to SAS-1 on the bottom expander module on the
ContentStore.
10. Power on Controller 1 by pressing the power button on the front panel of the ContentServer.
1 1. On the
Controller 1 changes to
1 2. Add the new ContentStore to the associated group as follows:
a. From the
b. From the
click
c. Click
1 3. Navigate to the
ContentServer controllers.
© 2017 Harmonic Inc. All rights reserved.
ContentServer Properties
Connected
to confirm.
ContentServer Properties
Connected
Cluster Properties
Group Properties
Add Server(s) to this Group
OK
to confirm, and then click
ContentServer Properties
Expanding a Harmonic MediaGrid 4000 Series System
page in SystemManager, verify that the
.
Shutdown
page in SystemManager, verify that the
.
page, click the associated
page, select the device you wish to add to the group, and then
.
Done
.
page and click the
67
Status
field for
button for Controller 1, and then
Status
field for
Group ID
.
Failback
button to balance the
Harmonic MediaGrid Release 4.1