Harmonic MediaGrid Installation And Configuration Manual page 80

Chapter 3 System Installation with the Content-
Server 3000 Series
To close a drawer:
1. Pull and hold both of the white latches on the sides of the drawer (see
2. Push the drawer in slightly.
3. Release the white latches and check they have returned to their original position.
4. Push the drawer all the way back into the enclosure, making sure it clicks home.
Figure 3–9: Drawer latch
Installing Drives
1. Open one drawer, as described in
2. Lower a disk drive into the slot, with the drive capacity label facing towards you, as shown in
Figure 3–10.
3. Push the drive downwards and hold it down while sliding the drive carrier plate in the
direction shown in
© 2017 Harmonic Inc. All rights reserved.
Opening and Closing a
Figure 3–10. This locks the drive in place.
80
Rack Mounting the Harmonic MediaGrid 3000 Series System
Drawer.
Harmonic MediaGrid Release 4.1
Figure 3–9).