Harmonic MediaGrid Installation And Configuration Manual page 268

Chapter 8 Hardware Reference
Figure 8–48: ContentStore 5840 and 5840A Operator's Panel LEDs
Table 8–46: ContentStore 5840 and 5840A Operator's Panel LEDs and Components
Component
Unit ID Display
Input Switch
Power On/Standby
Module Fault
Logical Status
Drawer 1/Drawer2 Fault
Drawer LEDs
The ContentStore 5840 and 5840A drawer LEDs display status for individual drawers.
© 2017 Harmonic Inc. All rights reserved.
Unit ID
Display
Input
Switch
Power On/
Standby
Module
Fault
Logical
Status
Drawer 1
Fault
Drawer 2
Fault
Usually shows the identification number (ID) for the
ContentStore. When the wink state is on, this flashes "88"
at a rate of approximately 1 Hz.
Use to set the ContentStore ID number. See
ContentStore 5840 Identification
Green: power is on.

Amber: system is in standby.

Amber indicates a fault in a PSU, cooling module or SBB
I/O module. Check the drawer LEDs to see if a drive fault
is indicated.
Amber indicates a fault from something such as a disk
drive, an SAS cable, or an internal or external RAID
controller. Check the drawer LEDs to see if a drive fault is
indicated
Amber indicates a fault in a drive, cable, or sideplane for
the specified drawer.
268
ContentStore 5840 and 5840A
Description
Setting the
Number.
Harmonic MediaGrid Release 4.1