Harmonic MediaGrid Installation And Configuration Manual page 136

Chapter 4 System Configuration
NOTE: If you are using an earlier version of OS X Server on the client computer, access the Open Directory
settings through
Directory Master
example.
Figure 4–5: Open Directory Server Admin
4. On each ContentDirector, use SSH to edit the file
authentication:
a. Change the value for HOST to the IP address of the Open Directory Server.
b. Change the entry "Base dc=example,dc=com" to the distinguished name of the search
base, which is the name that uniquely identifies an entry in the directory.
c. Edit the line "pam_password md5" as follows: pam_password
For the example shown in
HOST
URI ldap://10.2.2.252
BASE
pam_password
5. Save and close /etc/ldap.conf.
6. Open Directory uses TCP and UDP ports 389 and 636. If there is a firewall, please ensure
those two ports are opened in the firewall.
7. Open the
ContentDirectors and add the following lines:
admin_group_name = "diradmin"
auth_method = pam
The following is an example of the mdscore-local file:
#====================================================================
======#
#
Any options specified in here will override the same-named options in
the #
# main configuration file.
#====================================================================
======#
© 2017 Harmonic Inc. All rights reserved.
Server Admin
. From the
, and verify that the
Figure
10.2.2.252
dc=mediagrid,dc=com
exop
/omneon/config/mdscore-local
MDS coremain program local configuration file
Joining a Harmonic MediaGrid Cluster to an Apple Open Directory Domain
Overview
tab, ensure that the Open Directory is set to
LDAP Search Base
settings are correct. Refer to
/etc/ldap.conf
4–4, the values in /etc/ldap.conf should be as follows:
file on both the primary and secondary
136
Open
Figure 4–5 for an
as follows to set up LDAP
exop
.
Harmonic MediaGrid Release 4.1