Harmonic MediaGrid Installation And Configuration Manual page 323

Appendix A Legacy Hardware Platforms
2
1 3
8
Figure 9–11: Front View of ContentBridge 2010E
Table 9–12: ContentBridge 2010E Front Panel Components
Indicator, Button, or Connector
1. Power-on indicator/button
2. System identification button
3. Video Connector
4. LCD menu buttons
5. LCD display
6. USB connectors
7. Optical drive
8. Hard drive 0
9. Hard drive 1
Figure 9–12 and
© 2017 Harmonic Inc. All rights reserved.
5
4 6
< >
9
The power button controls the DC power supply output
to the system.
The power-on indicator lights when the system power is
on. When the power-on indicator is off, this indicates that
no power is supplied to the system.
The identification buttons on the front and back panels
can be used to locate a particular system within a rack.
When one of these buttons is pressed, the ID buttons on
the front and rear panels flash until one of the buttons is
pressed again.
Press to toggle the system ID on and off.
Connects a monitor to the system.
Allows you to navigate the control panel
LCD menu.
Displays system ID, status information, and system error
messages. The LCD lights blue during normal system
operation. The LCD lights amber when the system needs
attention, and the LCD panel displays an error code
followed by descriptive text.
Use to connect the front bezel.
Use for software installation.
Refer to
codes.
Table 9–13 describe the typical hard drive indicators and their functions.
Description
Table 9–13
for a description of the indicator
323
ContentBridge 2010E
7
Harmonic MediaGrid Release 4.1