Harmonic MediaGrid Installation And Configuration Manual page 53

Chapter 2 System Installation with the Content-
Server 4000 Series
NOTE: Once you have completed the network connections, group the cables and then secure them to the
rear side rails.
2. Using SAS cables, connect each ContentStore to the ContentServer.
Refer to

ContentServer 4000 to the ContentStore
3. Connect the Harmonic MediaGrid network switch to the client network.
Refer to

Network Switches to the Client Network: Two-rack
4. Connect power cables to each system component.

IMPORTANT: After connecting power cables, do not power on the system. You must configure the
network switches first. Refer to
Harmonic MediaGrid system.
Network Switch Connections
Figure 2–15 provides an overview of network switch connections. Not all connections are shown.
See the instructions following the illustration for each device's specific port connections.
IMPORTANT: Make sure to use only Harmonic MediaGrid-qualified switches in your Harmonic MediaGrid
system. To find out if a switch is Harmonic MediaGrid-qualified, contact your Harmonic representative.
NOTE: The switches shown in this section are example only. Your switch may vary from those shown.
© 2017 Harmonic Inc. All rights reserved.
Connecting the ContentServer 4000 to the ContentStore 4240
Connecting Network Switches to the Client Network: One-rack System
Refer to Connecting the Power Cables in a System with ContentServer 4000
Chapter 4, System Configuration
Connecting the Harmonic MediaGrid 4000 System Components
5840.
System, depending on the system setup.
for instructions for configuring your
53
or Connecting the
or Connecting
Series.
Harmonic MediaGrid Release 4.1