Harmonic MediaGrid Installation And Configuration Manual page 305

Appendix A Legacy Hardware Platforms
Table 9–4: ContentDirector Indicator Descriptions
NIC 0 Link
NIC 1 Link
NIC 2 Link
NIC 3 Link
Hard drive 0
Hard drive 1
Figure 9–4 and
Performance ContentDirector 2000B with the bezel removed. Note that your ContentDirector
may differ somewhat from the one described below.
2 3
1
8
Figure 9–4: Front View of ContentDirector
Table 9–5: Front Panel Components
Indicator, Button, or Connector
1. Power-on indicator/button
2. System identification button
3. Video connector
4. LCD menu buttons
© 2017 Harmonic Inc. All rights reserved.
LED Color/State
White
Red
White
Red
Table 9–5 detail the front panel view of a the ContentDirector 1000E and High
4 5
< >
9
ContentDirector 1000E and High Performance ContentDirector 2000B
Ethernet communications OK
Ethernet communications problem
Drive status OK
Drive error
6
10
The power button controls the DC power supply output
to the system.
The power-on indicator lights when the system power is
on. When the power-on indicator is off, this indicates that
no power is supplied to the system.
The identification buttons on the front and back panels
can be used to locate a particular system within a rack.
When one of these buttons is pressed, the ID buttons on
the front and rear panels flash until one of the buttons is
pressed again.
Press to toggle the system ID on and off.
Connects a monitor to the system.
Allows you to navigate the control panel
LCD menu.
305
Description
7
Description
Harmonic MediaGrid Release 4.1