Harmonic MediaGrid Installation And Configuration Manual page 39

Chapter 2 System Installation with the Content-
Server 4000 Series
The drive tray is in the correct position when its front edge lines up with the edge of the drive
bay.
3. Close the drive carrier lever to lock the drive into place.
Installing the Bezel on the ContentServer 4000 and ContentStore 4240
The bezel ships separately from the ContentServer and ContentStore. Follow these steps to install
the bezel on these units. You should mount the ContentServer or ContentStore on the rack prior
to installing the bezel, and disk drives should already be inserted.
1. Connect the cable inside the bezel to the 4-pin connector on the right side of the front panel.
2. Fit the posts on the right side of the bezel into the holes in the rack ear on the right side of
chassis.
The bezel cable should form a loop that fits inside the metal panel of the bezel.
3. Press in the release button on the left side of the bezel while pushing the left side of the bezel
straight onto the chassis, and then release the button.
The posts on the left side of the bezel will fit into the holes in the rack ear, securing the bezel
to the chassis.
IMPORTANT: For optimum airflow, do not obstruct the air vents on the bezel.
© 2017 Harmonic Inc. All rights reserved.
Rack Mounting the Harmonic MediaGrid 4000 Series System
2
3
39 Harmonic MediaGrid Release 4.1