Yamaha FZ09E 2014 Service Manual page 93

1. Air induction system hose (air filter case to air
cut-off valve)
2. Air filter case
3. Throttle cables
4. Stator coil assembly lead
5. Speed sensor lead
6. Clamp
7. Positive battery lead
8. Starter motor lead
9. Stator coil lead
10. Wire harness (to rectifier/regulator)
11. Gear position sensor lead
12. Sidestand switch lead
13. Oil level switch lead
14. Boots
15. Clutch cable
16. Intake air temperature sensor coupler
17. Air scoop stay
18. Wire harness protector
19. Coupler cover
20. Main switch coupler 1
21. Main switch coupler 2
22. Sponge
23. Sponge edge
24. Canister breather hose
A. Route the air induction system hose (air filter case
to air cut-off valve) inside the throttle cable.
B. To speed sensor
C. Route the fuel tank drain hose/breather hose out-
side to the wire harnesses.
D. Fasten the sidestand switch lead, stator coil
assembly lead, starter motor lead, oil level switch
lead, and the speed sensor lead with the clamp.
The order of the leads does not matter. Align the
clamp with the tape on the starter motor lead. Do
not cut off the clamp end and point it forward.
E. Route the gear position sensor lead inside to the
shift arm.
F. Hose bending edge
G. Align the sidestand switch lead, oil level switch
lead, fuel tank drain hose, and breather hose with
the bending edge of the hose, and then install
them. Face the clamp opening to the rearward.
H. 30–50 mm (1.18–1.97 in)
I. Point the tips of fuel tank drain hose and breather
hose as shown in the illustration.
J. Place the stator coil assembly lead so that bare
copper wires do not protrude from the boots.
K. Route the intake air temperature sensor lead
above the throttle cable in the frame, and feed it
outside the vehicle through the triangle hole in the
frame.
L. Install the clamp to the hole in the air scoop stay.
M. Install the intake air temperature sensor coupler
on the rib of the air scoop stay.
N. Install the clamp to the hole in the bottom of the
coupler cover.
O. Fasten the main switch coupler to the coupler
cover with the clamp.
P. Make sure that the main switch coupler does not
protrude from the sponge edge.
Q. Align the wire harness protector with the edge of
the Velcro tape and wrap it. However, the tape sur-
face may protrude somewhat.
R. For California only
S. Route the canister breather hose to the inside of
the stator coil assembly lead and starter motor
lead, also outside to the sidestand switch lead and
the oil level switch lead.
T. It does not matter whether the oil level switch lead
or the sidestand switch lead is on top.
U. It does not matter whether the fuel tank drain hose
or the breather hose is on top but make sure that
these hoses are not twisted each other.
2-58
CABLE ROUTING